normal resistance of a vehicle

Definition: The essential feature is recurrent obsessional thoughts or compulsive acts. Obsessional thoughts are ideas, images, or impulses that enter the patient's mind again and again in a stereotyped form. They are almost invariably distressing and the patient often tries, unsuccessfully, to resist them. They are, however, recognized as his or her own thoughts, even though they are involuntary and often repugnant. Compulsive acts or rituals are stereotyped behaviours that are repeated again and again. They are not inherently enjoyable, nor do they result in the completion of inherently useful tasks. Their function is to prevent some o ...[+++]bjectively unlikely event, often involving harm to or caused by the patient, which he or she fears might otherwise occur. Usually, this behaviour is recognized by the patient as pointless or ineffectual and repeated attempts are made to resist. Anxiety is almost invariably present. If compulsive acts are resisted the anxiety gets worse. | anankastic neurosis obsessive-compulsive neurosis

clean fuel vehicle [ clean-fuel vehicle ]

mine-hardened vehicle | mine-proof vehicle | mine-protected vehicle | mine-protective vehicle | mine-resistant vehicle | MPV [Abbr.]

Motor Vehicle Safety Regulations (School Bus Body Joint Strength)

Cleaner Vehicles and Fuels Task Group

The first would be an emissions factor specific to the vehicle, the second would be the amount the vehicle has been driven since the last time it was licensed, and the third would be a factor representing the local marginal damages per thousand kilometres from that vehicle class.

‘vehicle characteristics’ means the features of the vehicle, including mass, its specific CO2 emissions, the number of seats, engine performance, power to mass ratio and top speed;

The rolling resistance of the parent vehicle shall correspond to the original vehicle value proportionally adjusted to the parent vehicle mass measured or calculated as above:

‘Vehicle type’ means a category of power-driven vehicles, which do not differ in such essential respects as the dimensions, lines and materials of components of the vehicle structure or seat structure to which the safety-belts anchorages and the ISOFIX anchorages systems and ISOFIX top tether anchorages if any are attached and, if the anchorages strength is tested according to the dynamic test, as well as the vehicle floor strength when tested according to the static test in case of i-Size seating positions, the characteristics of any component of the restraint system, especially the load limiter function, having an influence on the forces applying to the safety-belt anchorages; ...[+++]