all fishing vessels and fish transport vessels registered in the EU or flying the flags of third countries and wishing to enter an EU port must be readily identifiable by means of the markings included in the FAO's Standard Specifications for the Marking and Identification of Fishing Vessels;

all fishing vessels and fish transport vessels registered in the EU or flying the flags of third countries and wishing to enter an EU port must be readily identifiable by means of the markings included in the FAO's Standard Specifications for the Marking and Identification of Fishing Vessels;

· all fishing vessels and fish transport vessels registered in the EU or flying the flags of third countries and wishing to enter an EU port must be readily identifiable by means of the markings included in the FAO's Standard Specifications for the Marking and Identification of Fishing Vessels;

Whereas, in view of the nature of the risks involved in the use of recreational craft and their components, it is necessary to establish procedures applying to the assessment of compliance with the essential requirements of the Directive; whereas these procedures must be devised in the light of the level of risk which may be inherent in recreational craft and their components; whereas, therefore, each category of conformity must be supplemented by an appropriate procedure or a choice between several equivalent procedures; whereas the procedures adopted comply with Council Decision 93/465/EEC of 22 July 1993 concerning the modules for the various phases of the conformity assessment procedures and the rules for the affixing and use of the CE c ...[+++]onformity marking which are intended to be used in the technical harmonization Directives (1);

1. Member States shall not prohibit, restrict or impede the placing on the market and putting into service in their territory of the products referred to in Article 1 (1) bearing the CE marking referred to in Annex IV, which indicates their conformity with all provisions of this Directive, including the conformity procedures set out in Chapter II.

3. Member States shall not prohibit, restrict or impede the placing on the market and putting into service of components referred to in Annex II and bearing the CE marking referred to in Annex IV which indicates their conformity with the relevant essential requirements where these components are intended to be incorporated into recreational craft, in accordance with the declaration, referred to in Annex IIIB, of the manufacturer, his authorized representative established in the Community or, in the case of imports from a third country, of any person who places those components on the Community market.