Foerstner bit

three-point safety belt | three-point inertia-reel seat belt | 3-point seatbelt

three-point seat belt

three-pin binding | 3-pin binding | 75 mm binding | toe-bail binding

3-point seat belt | three-point seat belt

three-point belt

three-points field goal

(e) no ITC on which a single aircraft is used may serve more than three points of origin and three points of destination, except that any number of points of destination may be served where all participants in the ITC visit each destination in turn;

Support was the highest for "helping the poor and socially excluded and enabling them to play an active part in society (79%, +3), "modernising labour markets, with a view to raising employment levels" (79%, +3) and "supporting an economy that uses less natural resources and emits less greenhouse gas" (76%, +3).

Europeans continue to broadly support the idea of "being stronger by working together" (see Annex): 79% (+2 percentage points from autumn 2010) are in favour of "a stronger coordination of economic policy among all the EU Member States, 78% (+3) are in favour of "a closer supervision by the EU when public money is used to rescue banks and financial institutions," 78% (+3) think that "a stronger coordination of economic and financial policies among the countries of the euro area" would be effective, 77% (+2) support a closer supervision by the EU of the activities of large financial groups" and 73% (+2) think that "a more important role f ...[+++]or the EU in regulating financial services" would be effective.

If the results of at least two of the three operations described in paragraph 3.2.4 above do not satisfy the requirements of paragraph 3.2.2 above, or if the verification cannot take place because the vehicle manufacturer has failed to supply information regarding the position of the ‘R’ point or regarding the design torso angle, the centroid of the three measured points or the average of the three measured angles shall be used and be regarded as applicable in all cases where the ‘R’ point or the design torso angle is referred to in this Regulation. ...[+++]