If the template cannot make simultaneous contact with the side reference line at points ‘A’ and ‘B’ and tangentially with the bonnet rear reference line, or the point at which the bonnet rear reference line and template touch lies within the arc scribed by points ‘C’ and ‘D’, then additional templates shall be used where the radii are increased progressively in increments of 20 mm, until all the above criteria are met.

The strategy may include measures to increase the length, track gauge, loading gauge, speed management, load hauled or axle load authorised for the trains running in the freight corridor.

The strategy may be based on increasing the length, gauge or axle load authorised for the trains running in the freight corridor.

32. Recognises, finally, that ERTMS can make an important contribution to the efficiency and attractiveness of European rail transport, particularly long-distance goods transport; stresses, however, that a number of harmonisation initiatives could be taken in addition to ERTMS which would lead to more efficient international rail travel in the relatively short term; calls for the European ERTMS coordinator and the future TEN Agency also to study the possibilities of harmonising, for example, train length, burden per axle, load capacity, etc; considers that these projects would have a relatively limited financial impact but quite a sig ...[+++]nificant outcome in terms of efficiency;

If the contact between the template and bonnet rear reference line is tangential and the point of tangency lies outside the arc scribed by points "C" and "D", then the bonnet rear reference line is extended and/or modified to follow the circumferential arc of the template to meet the bonnet side reference line, as shown in Figure 9.

If the template cannot make simultaneous contact with the bonnet side reference line at points "A" and "B" and tangentially with the bonnet rear reference line, or the point at which the bonnet rear reference line and template touch lies within the arc scribed by points "C" and "D", then additional templates should be used where the radii are increased progressively in increments of 20 mm, until all the above criteria are met.